Re: error codes

[Benjamin Story <bstory@bullets.net>]

Travis,

First as far as your posting problem, it sounds like you might not have the 
CPU jumpers set right.  Double check the bus speed and voltages.  Another 
thing that you can check is the RAM.  Sometimes the RAM won't seat all the 
way and you'll need to reinsert it.

In reference to the thermal grease, yes you should have either thermal grease 
or thermal tape between the processor and the heat sink so that the heat 
properly dissapates from the CPU.

Good Luck
Travis Davies <tddavies@yahoo.com> said:

> I got a new Motherboard. Its a asus A7M266ddr sdram
> socket A. When I try to boot it up the three lights on
> my keyboard turn on and I get no screen output. No
> beeps either. Once it booted up and the bios was said
> it was running at 900mhz. so when I configured it for
> 1200 it booted up again in some sort of bios safemode.
> any ideas?
> Amd athalon thunderbird 1200 2 levels of chache
> 
> Also, I was wondering, for AMD chips, is it absolutly
> necessary to put the thermal paste on?
> 
> Has anyone had a problem like this?
> 
> Travis
> 
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
> -
> To unsubscribe, send email to majordomo@luci.org with
> "unsubscribe luci-discuss" in the body.
> 



-- 
--
Benjamin Story


-
To unsubscribe, send email to majordomo@luci.org with
"unsubscribe luci-discuss" in the body.